If set to Monitor, any activity detected on the specified hardware peripherals or components will wake up the system or prevent the system from entering the power saving modes. Always consult the vendors for proper CPU cooling fan. Connect to the master drive. Please do not fold the serial ATA cable in a degree angle, for this might cause the loss of data during the transmission. Then click OK to apply the configuration. Look for the gold arrow. Using 2-, 4- or 6-Channel Audio Function.

Uploader: Bakinos
Date Added: 16 December 2005
File Size: 65.47 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 13251
Price: Free* [*Free Regsitration Required]

Can only enter but do not have the right to change the settings of the setup menu. Accurate international packging and shipment.

Disable the function if you want to use other controller cards to connect an audio device. For more information on 6-channel audio operation, please refer to Appendix. Hardware Setup Hardware Setup This chapter tells you how to install the CPU, memory modules, and expansion cards, as well as how to setup the jumpers on the mainboard.

System Time This allows you to set the system time that you want usually the current time.

MSI 865G Neo2-LS – motherboard – ATX – Socket 478 – i865G Series

Connect one end to the floppy disk drive connector FDD1 and the other end to the standard floppy disk. An operating sy ste m t hat supports HT Technology.


Combined Mode Option This item is neo2p- for you to select the combined mode which boots first. Note that this function applies only for 2-channel audio operation. Please be noted that not every memory is compatible with MAT.

Otherwise, the Line-Out connector on the back panel will not function. The Main Menu displays twelve configurable func- tions and two exit choices.

If you install two hard disks on cable, you must configure the second drive to Slave mode by setting its jumper. T is a utility that monitors your disk status to predict hard disk failure. When the CPU is temporarily suspending or staying in the low load balance, it will restore the default settings instead.

Support For G Neo2-PLS/ PFS | Motherboard – The world leader in motherboard design | MSI Global

Otherwise, the system may become unstable or even crash. The module will only fit in the right orientation. To operate properly, at least one DIMM module must be installed.

Bursting feature is a technique that DRAM itself predicts the address of the next memory location to be accessed after the first address is accessed.

SOLVED: Msi pe neo2-p (ms) – Fixya

Overclocking This mainboard is designed to support overclocking. Always read the safety instructions carefully.


Select- ing Fast will enable MAT. IDE1 can connect a Master and a Slave drive. Follow the procedures described below to install the drivers for different operating systems. Both connectors are fully 856g with Serial ATA 1.

Instant Repair Help over the Phone 6ya. Power LED is light green.

Perhaps even more impressive was how quickly the item arrived in Australia. Disabled Disables the onboard Floppy controller. Remember to disable Spread Spectrum if you are overclocking because even a slight jitter can introduce a temporary boost in clock speed which may just cause your overclocked processor to lock up.

Sergeant 2nd level of overclocking. You can clear CMOS by shorting pin while the system is off. Make sure to raise the lever up to a degree angle. CPU support can be attested to looking at the specs for the motherboard chipset, on your motherboard. ALC allows the board to attach 4 or 6 speakers for better surround sound effect.